Tools & Brushes

Products In This Category

Displaying products 1 - 30 of 334 results
Page 1 of 12 Page 12345...12movenext
$15.15
This block is made of aloxite, a fine, hard abrasive material. Excellent for grinding glaze runs and rough spots on both glazes and bisque ware. 200 mesh, 80 grit, K grade. 2"x 4"x 3/4"
$6.15
After firing, remove unsightly stilt marks with this Aloxite Stilt Mark Stone. In seconds, you can gently and easily remove stilt marks with these slender 4" long, 3/8" x 3/8" bar. 200 mesh, 80 grit, K grade.
$13.80
This block is made of aloxite, a fine, hard abrasive material. Excellent for grinding glaze runs and rough spots on both glazes and bisque ware. 200 mesh, 80 grit, K grade. 2"x 2.5"x 1"
$18.40
A fluted, silicon carbide brick 8" long, 2" x 2" square bar. Very effective at cleaning glaze drips and excessive build up of kiln wash from kiln shelves.
$24.30
A fluted, silicon carbide brick 6" long, 3" x 1" bar. Very effective at cleaning glaze drips and excessive build up of kiln wash from kiln shelves.
$9.00
Contains one each: sponge, squat wooden rib, loop trimming tool, double sided ribbon trimming tool, needle tool, long wooden rib, cut off wire, and aluminum scraper. All tools are about 3.0" to 8.0" long.
$17.00
This tool set contains ten wooden modeling and cutting tools. All tools are about 8" long.
$7.00
For decorating clay with textures of dragon, snake, fish scales or roof tiles. Approximately 7" long.
$7.89
Perfect for rolling small amounts and portions of clay, the two rollers are held together with stainless steel. Both rollers have a 1" diameter, the shorter side is 2.45" and the longer side is 4.15" wide.
$1.69
Used to help with the forming, trimming or decorating of a ceramic piece. Measures approximately 4.0" x 1.65".
$2.95
Used for finishing and decorating ceramic forms. Measures approximately 4.0" x 3.4".
$3.29
Used for finishing and decorating ceramic forms. Measures approximately 4.65" x 3.0".
$47.95
8-piece Wide wood edge trim tool set. Each tool measures approximately 3.1" x 1.6".
$8.00
Two Sided Handle Maker Tool. Measures approximately 6.5" with a 1" wide end.
$2.49
Wire End Tool. Measures approximately 8.0" x 0.9".
$1.79
Synthetic Sponge (6.0" x 2.5" x 1.25")
$4.49
Genuine Chamois (approx. 5.0" x 7.0") Size and shape may vary.
$0.80

Synthetic Sponge (2.5" x 1")
ratingratingratingratingrating
$1.92

Synthetic Sponge (5" x 4" x 1.75")
$6.48
Natural Elephant Ear Sponge (large). This is a natural sponge, measurements vary but are approximately 3-4".
$4.74
Rock Island Sea Wool Sponge - Natural (apx 4" - 5")
$1.38
Silk Sponge - Natural (2.5"-3")
$2.95
This natural bristle detail set with it's flat and three tapered points will give you a variety of tips to allow for detail work. Brushes measure approximately 6.5" - 7.5" long.
$1.95
A great brush set for detailing. These brushes will spread the glaze well for fine lines and detailed work. Brushes measure approximately 6.75" - 7.0" long.
$9.00
Fan Brush set; set of 6. #2, #4, #6, #8, #10, & #12.
$1.95
Holds glaze and spreads evenly for short strokes. Brushes measure approximately 6.6" - 7.0" long.
$11.00
Bevel Cutter Tool, 45° and 60° (measures approximately 3" x 1.5")
$13.00
Bevel Cutter Tool for rounded edges; 10mm and 15mm
$7.00
Small Bevel Cutter Tool, 45° and 60° (measures approximately 2" x 0.75")
$10.00
5 piece set, head 1/8" soft rubber pens - good for sgraffito, modeling, soft slab decorating and underglaze/glaze dotting.
Page 1 of 12 Page 12345...12movenext