Refractories & Firing

Products In This Category

Displaying products 151 - 165 of 165 results
Page 6 of 6 Page moveprev1...23456
$69.95
Analogue pyrometer to assist in reading the interior temperature of your kiln; reads up to 2500°F. Meter marked so you can make both Centigrade or Fahrenheit readings.
$99.95
Digital handheld pyrometer to assist in reading the interior temperature of your kiln; Single Input K-Type Thermocouple Thermometer with a -58 to +2,462 °F range.
$19.95
Replacement Temperature Probe for TPI341KC1 Digital Pyrometer
$1.15
Wire to connect an analogue pyrometer to thermocouple. (sold by the foot).
$23.00
K Type Thermocouple; available in 6", 8" or 12" lengths.
$27.80
12" Protection Tube for K Type Thermocouple. Inner Diameter 0.45", Outer Diameter 0.7"
$14.00
Thermocouple for Skutt KM Kilns; thermocouple only, no block. 6".
$28.50
9" OxyProbe Protection Tube replacement.
$29.75
Colloid Silica Rigidizer. This liquid material has several uses in connection with fiber insulation materials. Sold by the gallon.
$10.09
Used to support beads, rings and many other small articles during kiln firing. Approximately 11" long, the Ceramic Bead Bars are designed with a special, high temperature alloy. Support properly. Approx 0.15" dia.
$4.75
For small cones. Holding pyrometric cones in the correct position is the way to obtain the most accurate indication of proper firing. Heat resistant wire gives these holders long life and durability. Five holders in each package.
$5.65
For large cones. Holding pyrometric cones in the correct position is the way to obtain the most accurate indication of proper firing. Heat resistant wire gives these holders long life and durability. Five holders in each package.
$10.00
For pyrometric small cones and pyrometric bars. Fits all models of Kiln-Sitter. Each cone support is approximately 1.35" long by 0.35" wide.
$59.99
These Raku Tongs are used to place ware into a hot raku kiln or remove hot ware from a raku kiln. They are 41 inches long, have smooth jaws and open to 37°.
$62.50
These Raku Tongs are used to place ware into a hot raku kiln or remove hot ware from a raku kiln. They are 31 inches long, have teeth and open to 45°.
Page 6 of 6 Page moveprev1...23456