|
|
Kiln Furniture & Supplies
Products In This Category
Star stilts. Each stilt measures approximately 1-3/4" point to point and 3/8" high. Sold in sets of 12.
|
Star stilts. Each stilt measures approximately 2-1/4" point to point and 3/8" high. Sold in sets of 12.
|
Star stilts. Each stilt measures approximately 2-1/2" point to point and 3/8" high. Sold in sets of 12.
|
#4x6 Steel Multipoint Stilts. Sold in sets of 12.
|
Setter for beads, buttons, trinkets, etc. Length is 4”, height is 2”. Comes with four 6” rods. Maximum recommended firing range: 2250° F.
|
Two durable stoneware supports with 10" long wires, provide a versatile, space-saving device for firing macrame beads and other larger hanging objects. Base is 3.25" x 1.5"; 6.5" H and uprights are 2" W x 5/16" thick.
|
This block is made of aloxite, a fine, hard abrasive material. Excellent for grinding glaze runs and rough spots on both glazes and bisque ware. 200 mesh, 80 grit, K grade. 2"x 4"x 3/4"
|
After firing, remove unsightly stilt marks with this Aloxite Stilt Mark Stone. In seconds, you can gently and easily remove stilt marks with these slender 4" long, 3/8" x 3/8" bar. 200 mesh, 80 grit, K grade.
|
This block is made of aloxite, a fine, hard abrasive material. Excellent for grinding glaze runs and rough spots on both glazes and bisque ware. 200 mesh, 80 grit, K grade. 2"x 2.5"x 1"
|
A fluted, silicon carbide brick 8" long, 2" x 2" square bar. Very effective at cleaning glaze drips and excessive build up of kiln wash from kiln shelves.
|
A fluted, silicon carbide brick 6" long, 3" x 1" bar. Very effective at cleaning glaze drips and excessive build up of kiln wash from kiln shelves.
|
2" long, 13/16" top diameter, 1.75" bottom diameter plug for kiln peepholes.
|
approximate measurements: 3.5" long, 1.25" top diameter, 0.75" bottom diameter plug for kiln peepholes.
|
 A 2" diameter Ceramic Washer used to secure Ceramic Fiber to an outer frame. For use with nichrome tie wire. Works well with 15 gauge Nichrome wire (pictured, but not included). Can be fired up to Cone 12.
|
Used to support beads, rings and many other small articles during kiln firing. Approximately 11" long, the Ceramic Bead Bars are designed with a special, high temperature alloy. Support properly. Approx 0.15" dia.
|
|
|