|
|
Abrasives
Products In This Category
Silicon Carbide Bench Grinding Wheel. 6 inch diameter by 0.75 inches thick. 80 grit. Will fit arbor shafts of 1/2", 5/8" and 3/4". 6 x 3/4 x 1
|
Replacement Silicon Carbide Grinding Belt for CiProducts Grinder Kit. 3" x 24".
***Actual size measures 25 1/2" around.
|
12 inch diameter grinding disk with a peel-off adhesive backing. Permanently affix this disk to any 12 inch bat. 50 grit.
|
12 inch diameter grinding disk with a peel-off adhesive backing. Permanently affix this disk to any 12 inch bat. 80 grit.
|
This block is made of aloxite, a fine, hard abrasive material. Excellent for grinding glaze runs and rough spots on both glazes and bisque ware. 200 mesh, 80 grit, K grade. 2"x 4"x 3/4"
|
After firing, remove unsightly stilt marks with this Aloxite Stilt Mark Stone. In seconds, you can gently and easily remove stilt marks with these slender 4" long, 3/8" x 3/8" bar. 200 mesh, 80 grit, K grade.
|
This block is made of aloxite, a fine, hard abrasive material. Excellent for grinding glaze runs and rough spots on both glazes and bisque ware. 200 mesh, 80 grit, K grade. 2"x 2.5"x 1"
|
A fluted, silicon carbide brick 8" long, 2" x 2" square bar. Very effective at cleaning glaze drips and excessive build up of kiln wash from kiln shelves.
|
A fluted, silicon carbide brick 6" long, 3" x 1" bar. Very effective at cleaning glaze drips and excessive build up of kiln wash from kiln shelves.
|
|
|