|
|
Gas Burners & Accessories
Products In This Category
This venturi burner is complete with a flame retention feature within a single casting. The overall length of this burner is 8", and the range of BTU's spans from 17,490 BTU minimum to 78,440 BTU maximum...
|
This venturi burner kit is an excellent option for your raku kiln; for use with propane.
|
This burner is 12” long and will produce between 29,900 to 356,400 BTUs depending on the gas pressure, type of gas and size of orifice.
|
This burner is 17” long and will produce between 48,900 to 495,300 BTUs depending on the gas pressure, type of gas and size of orifice.
|
This burner is 21” long and will produce between 58,700 to 649,400 BTUs depending on the gas pressure, type of gas and size of orifice.
|
1/2" x 1/4" Hose Bushing (red).
|
Burner accessory. Hose fit connector. 9/16 18 LH x 1/4 MNPT.
|
Orifice replacement for Laguna and Venturi burners for natural gas. ~1/8" aperture.
|
Orifice replacement for Laguna and Venturi burners for propane. ~1/16" aperture.
|
Use to control a fuel's flow with the turn of a handle. Inner thread measures 1/4". Brass body, 600 WOG rated.
|
Use to control a fuel's flow with the turn of a handle. Inner thread measures 1/2". Brass body, 600 WOG rated.
|
Use to control a fuel's flow with the turn of a handle. Inner thread measures 3/4". Brass body, 600 WOG rated.
|
Use to control and regulate a fuel's flow.
|
Use to control and regulate a fuel's flow.
|
Use to control and regulate a fuel's flow.
|
Use to control and regulate a fuel's flow.
|
Use to connect a fuel source to a kiln.
|
Use to measure the air pressure of a regulated fuel. Note: Has 1/4" MPT with a bottom inlet.
|
Invaluable for trying to establish a kiln firing schedule. It measures the gas pressure to the burners as an indication of how much gas is entering the kiln. Reads gas pressure on a calibrated scale of 0-15" of water column pressure.
|
Invaluable for trying to establish a kiln firing schedule. It measures the gas pressure to the burners as an indication of how much gas is entering the kiln. Reads gas pressure on a calibrated scale of 0-30" of water column pressure.
|
Can regulate air or liquid; this direct-operated regulator is designed for high-pressure service and can be used on either air or liquid gas applications. Recommended for a small gas or Raku kiln. Reads 3-35 psi with gauge, 750,000 BTU/h. 1/4 thread.
|
|
|