AccuAngle

A bevel cutting tool for hand building and clay tile artists. Available in two different lengths 16" and 32". Designed for use with any long needle tool.

The AccuAngle is designed to use with any long needle tool(not included). It is available in two different lengths, 16" or 32". The holes in the sliding cutter are preset at specific angles, for example, the lowest hole (#3) cuts a 30 degree angle (Full list of angles below). With the ruler resting on top of the clay slab insert the sliding cutter into the rule. Position the sliding cutter just off the edge of the slab. Insert your needle tool into the desired angled hole and allow the tip to rest on the cutting surface. Grasp the cutting slider at either end using the thumb and middle finger. Pull towards you.

Full List of Angle(s) for the sliding cutter

• #3 - 30 degree angle, can be used to create an equilateral triangle
• #4 - 45 degree angle, can be used to create a rectangle
• #5 - 54 degree angle, can be used to create a pentagon
• #6 - 60 degree angle, can be used to create a hexagon
• #7 - 64.2 degree angle, can be used to create a heptagon
• #8 - 67.5 degree angle, can be used to create an octogon
• #9 - 70 degree angle, can be used to create a nonagon
• #10 - 72 degree angle, can be used to create a decagon
• #11 - 73.6 degree angle, can be used to create a hendecagon
• #12 - 75 degree angle, can be used to create a dodecagon
• The Un-numbered hole closest to the rulers edge is a 90 degree angle